81 | Functions of the System
ETAS ES800 System | User Guide
- A device connected to one of the Ethernet HOST interfaces being removed
or switched off (e.g. PC)
- Data traffic no longer being detected at one of the Automotive Ethernet,
FlexRay, CAN-FD, CAN or LIN bus interfaces (ES88x/ ES89x only in conjunc-
tion with ES820.1 or with ES830.1).
ES820.1 Drive Recorder
When using the ES820.1 Drive Recorder, further events can trigger the module to
change from the "On" operating state to the "Standby" operating state:
- The completion of the measurement task
- Pressing the "Power" button on the front plate
- Pressing an external "Power" button, if it is connected to the "I/O" interface
- Switching off the ignition (Kl.15), if it is connected to the "I/O" interface
- Reaching a predefined point in time
ES830.1 Rapid Prototyping Module
When using the ES830.1 Rapid Prototyping Module, further events can trigger the
module to change from the "On" operating state to the "Standby" operating state:
- Pressing the "Power" button on the front plate
- Pressing an external "Power" button, if it is connected to the "I/O" interface
- Switching off the ignition (Kl.15), if it is connected to the "I/O" interface
To Next Page
Loading...
