Operating manual
CNC 8055
CNC 8055i
EDIT
5.
·T· MODEL
SOFT: V02.2X
·101·
Replace
5.4 Replace
With this option it is possible to replace a character sequence with another throughout the selected
program.
When selecting this option, the CNC requests the character sequence to be replaced. Once the text
to be replaced is indicated, press the "WITH" softkey and the CNC will request the character
sequence which will replace the previous one.
Once this text has been keyed in, press the "END OF TEXT" softkey and the cursor will position
over the first occurrence of the keyed text.
The search will begin from the block the cursor is position on beginning at that block.
The found text will be highlighted and the following softkey options will appear:
REPLACE
It will replace the highlighted text and will continue the search for the indicated text.
This search will be carried out from the text that was replaced up to the end of the program. If no
more occurrences of the text to be replaced are found, the CNC will quit this mode.
The new text found will be highlighted and the softkeys will show the same "replacing" or "not
replacing" options.
DO NOT REPLACE
It will NOT replace the highlighted text and will continue the search for the indicated text.
This search will be carried out from the text that was replaced up to the end of the program. If no
more occurrences of the text to be replaced are found, the CNC will quit this mode.
The new text found will be highlighted and the softkeys will show the same "replacing" or "not
replacing" options.
TO THE END
This option will find and replace the selected text throughout the whole program.
This "find and replace" will start at the highlighted text and will go on to the end of the program.
ABORT
This option will not replace the highlighted text and it will quit the "find and replace" mode.
To Next Page
Loading...
Need help?
General
