Fagor CNC 8055 T User Manual

·102·
Operating manual
CNC 8055
CNC 8055i
5.
EDIT
·T· MODEL
SOFT: V02.2X
Delete block
5.5 Delete block
With this function it is possible to delete a block or group of blocks.
To delete only one block, just position the cursor over it and press [ENTER].
To delete a group of blocks, indicate the first and last blocks to be deleted. To do that, proceed as
follows:
1. Position the cursor over the first block to be deleted and press the "INITIAL BLOCK" softkey.
2. Position the cursor over the last block to be deleted and press the "FINAL BLOCK" softkey.
If the last block to be deleted is also the last one of the program, it can also be selected by pressing
the "TO THE END" softkey.
3. Once the first and last blocks are selected, the CNC will highlight the selected blocks requesting
confirmation to delete them.

Fagor CNC 8055 T Specifications

General

Brand	Fagor
Model	CNC 8055 T
Category	Power Tool
Language	English