Operating manual
CNC 8055
CNC 8055i
UTILITIES
8.
·T· MODEL
SOFT: V02.2X
·149·
Accessing the programs without using the explorer
8.1.4 Rename
To rename or assign a new comment to a program stored in the CNC's RAM memory, in the hard
disk (KeyCF) or in the USB disk.
To rename a program, proceed as follows:
1. Press the "RENAME" softkey.
2. Indicate the location of the program or programs to be renamed.
The CNC's RAM memory, hard disk (KeyCF), USB disk and external devices (serial line).
3. Indicate the number of the program to be renamed.
4. Select the program with the arrow keys and press [ENTER] or key in its number and press the
"TO" softkey.
5. Press the softkey NEW NUMBER or NEW COMMENT.
6. Enter the new number or the new comment and press [ENTER].
The files associated with the PLC (program, messages and errors) are always referred to with their
associated mnemonics, thus only their comments may be renamed.
If there is a program with the same number, the CNC will issue a warning message and it will offer
the chance to modify the command.
Examples:
• To change the name of program 200103 of the hard disk (KeyCF).
• To change the comment of program 100453 from the CNC
RENAME (HARD DISK) P200103
A NEW NUMBER P12 ENTER
RENAME (MEMORY) P100453
A NEW PROFILE "HELLO" ENTER
To Next Page
Loading...
Need help?
General
