Operating manual
CNC 8055
CNC 8055i
CNC - PC COMMUNICATION. TELEDIAGNOSIS
14.
·T· MODEL
SOFT: V02.2X
·243·
Direct connection through the serial line or Ethernet
14.1 Direct connection through the serial line or Ethernet
The direct connection is also possible either through the RS232 serial line or Ethernet. With the
Ethernet connection it is possible to use a local network to access any CNC of the network from
the PC.
The connection is established from the PC through the WinDNC. Refer to the WinDNC help for
further information.
For the RS232 connection, the remote PC must have the WinDNC software (version V2.00 or later)
installed in it. For the Ethernet connection, the remote PC must have the WinDNC software (version
V4.00 or later) installed in it.
To Next Page
Loading...
