CNC 8055
CNC 8055i
·11·
SAFETY CONDITIONS
Read the following safety measures in order to prevent harming people or damage to this product and those
products connected to it.
The unit can only be repaired by personnel authorized by Fagor Automation.
Fagor Automation shall not be held responsible of any physical or material damage originated from not
complying with these basic safety rules.
PRECAUTIONS AGAINST PERSONAL HARM
• Interconnection of modules.
Use the connection cables provided with the unit.
• Use proper Mains AC power cables
To avoid risks, use only the Mains AC cables recommended for this unit.
• Avoid electric shocks.
In order to avoid electrical discharges and fire hazards, do not apply electrical voltage outside the range
selected on the rear panel of the central unit.
• Ground connection.
In order to avoid electrical discharges, connect the ground terminals of all the modules to the main
ground terminal. Before connecting the inputs and outputs of this unit, make sure that all the grounding
connections are properly made.
• Before powering the unit up, make sure that it is connected to ground.
In order to avoid electrical discharges, make sure that all the grounding connections are properly made.
• Do not work in humid environments.
In order to avoid electrical discharges, always work under 90% of relative humidity (non-condensing)
and 45 ºC (113º F).
• Do not operate this unit in explosive environments.
In order to avoid risks, harm or damages, do not work in explosive environments.
To Next Page
Loading...
Need help?
General
