Operating manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
12.
·T· MODEL
SOFT: V02.2X
·219·
Operation with parameter tables
"FIND" softkey
This option is used to find a specific text within the selected table.
When selecting this option, the softkeys will show the following options:
BEGINNING When pressing this softkey, the cursor positions over the first parameter
of the table quitting this option.
END When pressing this softkey, the cursor positions over the last parameter
of the table quitting this option.
PARAMETER When pressing this softkey, the CNC will request the number of the
parameter to be found. Key in that number and press [ENTER]; the cursor
will be positioned over the indicated parameter quitting this option.
"INITIALIZE" softkey
With this option it is possible to reset all the parameters of the selected table to their default values.
These default values are indicated in the chapter corresponding to machine parameters in the
installation manual.
"LOAD" softkey
The tables may be loaded from the hard disk (KeyCF") or a peripheral device or a PC through the
serial line (RS232C).
The transmission starts after pressing the corresponding softkey. When using a serial line, the
receptor must be ready before starting the transmission. To interrupt the transmission, press the
"ABORT" softkey.
If the length of the table received does not coincide with the current table length, the CNC will act
as follows:
• If the table received is shorter than the current one, the received lines are modified and the rest
remain with their previous values.
• If the table received is longer than the current one, all the lines of the table are modified and when
detecting that there is no more room, the CNC will issue the corresponding error message
"SAVE" softkey
The tables may be saved into the hard disk (KeyCF") or a peripheral device or a PC through the
serial line (RS232C).
The transmission starts after pressing the corresponding softkey. When using a serial line, the
receptor must be ready before starting the transmission. To interrupt the transmission, press the
"ABORT" softkey.
"MM/INCHES" softkey
Every time this softkey is pressed, the CNC will change the display format of those parameters
affected by these units from millimeters to inches and vice versa. The lower right-hand window will
indicate which units are selected (MM/INCH).
Note that this change does not affect the general machine parameter "INCHES" which indicates
the measuring units by default.
To Next Page
Loading...
Need help?
General
