Operating manual
CNC 8055
CNC 8055i
CNC - PC COMMUNICATION. TELEDIAGNOSIS
14.
·T· MODEL
SOFT: V02.2X
·247·
Advanced phone call
How to operate at the PC
While the CNC is dialing, the task bar will show an icon indicating the telephone access connection.
At that moment, a new configuration must be created at the WinDNC. Select "Network Node" in the
"Type" field and as IP address the one previously configured (in our example 10.0.68.71).
Press "OK" to finish creating the configuration and "Connect" to connect to the CNC.
Disconnecting the CNC from the Ethernet network during
telediagnosis
For safety reasons, the CNC offers the operator the possibility to temporarily disconnect the CNC
from the Ethernet network during the call. Pressing the "Call" softkey opens a new window for
temporarily disconnecting the CNC from the Ethernet network. The CNC will connect to the network
again when the call ends.
When the CNC disconnects from the Ethernet network, the Ethernet status screen will show the
message "Ethernet not running".
This type of telediagnosis uses a standard Windows protocol which like other packs involves opening
a communications port at the PC (incoming connection). Having this open pot may let an undesired
third party access the PC and even the local network.
To prevent undesired access, the PC should be disconnected from the local network during
telediagnosis; once telediagnosis has concluded, the incoming connection must be disconnected.
To Next Page
Loading...
Need help?
General
