·36·
Operating manual
CNC 8055
CNC 8055i
1.
OVERVIEW
·T· MODEL
SOFT: V02.2X
Keyboard layout
Direct access to the execution mode, "EXEC" key.
Pressing this key starts the execution of the last program edited, simulated or executed. If there is
no previous program, it requests the name of a new program.
If the simulation or execution mode is active, only the active mode will be shown, no program is
selected.
To restrict the execution to the last program edited, simulated or executed, assign to the NEXEXE
variable one of the following values:
NEXEXE=0 Not restricted, it opens the last one edited, simulated or executed.
NEXEXE=1 Always the last program edited.
NEXEXE=2 Always the last program simulated.
NEXEXE=3 Always the last program executed.
If the corresponding program is being executed or simulated, it issues a warning. If there is no
previous program, it requests the name of a new program.
To Next Page
Loading...
Need help?
General
