Fargo DTC550 - Page 113

FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
4-8
Troubleshooting the LCD Messages (continued)
LCD Message Cause Solution
INVALID RIBBON
2
The print Ribbon installed
in the Printer does not
match the Ribbon type
set in the Printer.
Get the correct Ribbon from your
dealer. See the Resolving the
Wrong Print Ribbon Error
Message.
INVALID RIBBON
3
The print Ribbon installed
in the Printer does not
match the Ribbon type
set in the Printer.
Get the correct Ribbon from your
dealer. See the Resolving the
Wrong Print Ribbon Error
Message.
JOB DATA ERROR The print data sent to the
Printer is corrupt or has
been interrupted.
Check the interface cable and
cancel the print job from the PC.
Press CANCEL to abort this print
job and then resend the job.
LAM CARD FLIP
ERROR
A problem has been
detected in the Laminator
flipper.
If this problem persists, call for
technical assistance.
LAM ERROR The Lamination module
requires attention.
Check the indicated condition and
correct it, using the Laminator's
control buttons. Press QUIT to
clear this message.
LAM HANDLER
STARTUP
See the next column. If this problem persists, call for
technical assistance.
LAM LIFT ERROR See the next column. If this problem persists, call for
technical assistance.
LAM MATERIAL
LOW
Lamination material is
low.
LAM MEMORY
ERROR
See the next column. If this problem persists, call for
technical assistance.