FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
4-9
Troubleshooting the LCD Messages (continued)
LCD Message Cause Solution
LAM STARTUP
ERROR
See the next column. If this problem persists, call for
technical assistance.
LAM TAG ERROR The Ribbon identification
tag cannot be read.
Install a new film roll and press
RESUME to continue or CANCEL
to abort. If the problem persists,
call for technical assistance.
MAG CARD JAM A card jam has been
detected in the MAG
encoding section of the
Printer.
Clear the jam according to the
steps in the Troubleshooting
section of the User Guide.
MAG ENCODER
PAUSED
The head arm assembly
has been opened during
Magnetic Encoding
causing this operation to
halt.
Press RESUME to retry or
CANCEL to abort.
MAG ENCODER
STARTUP ERROR
A problem has been
detected in the MAG
encoding section of the
Printer during start-up.
If this problem persists, call for
technical assistance.
MAG VERIFY
FAILURE
Print could not verify
MAG write.
NO FLIPPER
INSTALLED
Two sided job sent to a
one sided Printer.
NO MAG
INSTALLED
MAG encoding job sent
to Printer without MAG
encoder.
NO RIBBON
INSTALLED
There is no Ribbon
installed or it is broken.
To Next Page
Loading...
