Fargo DTC550 - Page 115

FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
4-10
Troubleshooting the LCD Messages (continued)
LCD Message Cause Solution
OPEN PRINT ARM Cover and print arm must
be opened for Printer
cleaning.
Open cover and print arm and
retry.
PANEL STARTUP
ERROR
A problem has been
detected in the print
section of the Printer
during start-up.
If this problem persists, call for
technical assistance.
PLEASE REMOVE
CARD
Exception recovery
cannot position a card
located in the Printer.
Please remove or reposition the
card and press RESUME to
continue.
PLEASE REMOVE
RIBBON
See the next column. The Ribbon must be removed at
this point to properly calibrate the
Sensor.
PRINT RIBBON
LOW
The print Ribbon will soon
run out.
If printing a large number of cards
replace the Ribbon now or monitor
the Printer until the Ribbon is gone
and install a new Ribbon.
PRINT RIBBON
OUT
The print Ribbon has run
out.
Install a new Ribbon and press
RESUME to continue or CANCEL
to abort.
REINSERT
RIBBON
The Ribbon must be
reinserted for proper
functioning of the Printer.
Reinsert the Ribbons or press
RESUME.
RIBBON ALIGN
ERROR
The print Ribbon is either
damaged or the Printer is
not calibrated.
Replace the Ribbon or recalibrate
according to the steps in the
Troubleshooting section of the
User Guide. Press RESUME to
continue or CANCEL to abort. See
Resolving the Ribbon Alignment
Error Message.