FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
v
Resolving the Ribbon wrinkle problems ______________________________________________ 4-45
Resolving the excessive Resin Printing problems _______________________________________ 4-47
Resolving the incomplete Resin Printing problems ______________________________________ 4-49
Resolving the cut off or off-center Card Image problems _________________________________ 4-51
Resolving the poor Image Quality problems ___________________________________________ 4-53
Printing a Test Image _______________________________________________________________ 4-54
Printing a Print Test Image_________________________________________________________ 4-54
Reviewing the Gray/Align YMC/K Self-Test __________________________________________ 4-54
Reviewing the Color/Resin YMCK Self-Test __________________________________________ 4-55
Reviewing the Color Bars YMC Self-Test_____________________________________________ 4-55
Reviewing the Printer Settings Self-Test ______________________________________________ 4-56
Reviewing the Magnetic Test option _________________________________________________ 4-56
Section 5: Card Lamination Module __________________________________________5-1
Adjusting a Card Lamination Module____________________________________________________ 5-1
Adjusting the Card Flattener ___________________________________________________________ 5-1
Adjusting the Card Guide Rail _________________________________________________________ 5-3
Adjusting the Internal Card Guide ______________________________________________________ 5-7
Attaching the Card Lamination Module _________________________________________________ 5-10
Performing the procedure for the DTC550 Card Lamination Module Attachment Kit______________ 5-11
Section 6: Printer Adjustments_______________________________________________6-1
Using the Card tab___________________________________________________________________ 6-1
Selecting the Card Size_____________________________________________________________ 6-2
Using the Card Hopper Selection option _______________________________________________ 6-4
Adjusting the Orientation Option _____________________________________________________ 6-7
Selecting the number of Copies ______________________________________________________ 6-8
Using the Diagnostics button under the Card tab _________________________________________ 6-9
Using the Clean Printer Option______________________________________________________ 6-10
Using the Test Print button_________________________________________________________ 6-12
Using the About button____________________________________________________________ 6-13
Using the Device Options tab _________________________________________________________ 6-14
Adjusting for the Ribbon Type option ________________________________________________ 6-15
Selecting the Auto Ribbon Select option ______________________________________________ 6-16
Adjusting for the Color matching____________________________________________________ 6-17
Adjusting for the Resin Dither ______________________________________________________ 6-18
Using the Print Both Sides option ___________________________________________________ 6-19
Using the Split 1 Set of Ribbon Panels option __________________________________________ 6-20
Using the Print Back Side First option ________________________________________________ 6-21
Using the Print on Back Side Only option _____________________________________________ 6-22
Using the Rotate Front by 180 Degrees option__________________________________________ 6-23
Using the Rotate Back by 180 Degrees option__________________________________________ 6-24
Using the Disable Printing option____________________________________________________ 6-25
Using the Image Color tab____________________________________________________________ 6-26
Using the Resin Heat (K) option (Front and Back) ______________________________________ 6-30
Using the Overlay Heat (O) option___________________________________________________ 6-31
Using the Image Color option and Default button _______________________________________ 6-32
Using the Calibrate tab ______________________________________________________________ 6-33
Using the Image Position Controls___________________________________________________ 6-34
Using the Sensors button __________________________________________________________ 6-36
Using the Settings button __________________________________________________________ 6-37
Using the Printer Calibration Utility__________________________________________________ 6-38
Using the Image Darkness Option ___________________________________________________ 6-39
Using the Print Top of Form Option__________________________________________________ 6-40
Using the Print End of Form Option__________________________________________________ 6-41
Using the Print Left of Form Option _________________________________________________ 6-42
To Next Page
Loading...
Need help?
General
