Fargo DTC550 User Manual

FOR RESTRICTED USE only Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
vi
Using the Mag Top of Form Option__________________________________________________ 6-43
Using the Ribbon Tension Option ___________________________________________________ 6-45
Using the Magnetic Encoding tab ______________________________________________________ 6-46
Using the Encoding Mode option____________________________________________________ 6-47
Using the Coercivity Selection______________________________________________________ 6-49
Using the Magnetic Track Selection option ____________________________________________ 6-50
Reviewing the Enable MLE Support checkbox _________________________________________ 6-51
Using the Magnetic Track Options___________________________________________________ 6-52
Using the Bit Density radio buttons __________________________________________________ 6-53
Using the Character Size radio buttons________________________________________________ 6-54
Using the ASCII Offset radio buttons_________________________________________________ 6-55
Using the LRC Generation radio buttons ______________________________________________ 6-56
Using the Character Parity radio buttons ______________________________________________ 6-57
Reviewing the Shift Data Left ______________________________________________________ 6-58
Reviewing the ISO Track Locations__________________________________________________ 6-59
Reviewing the Sample String _______________________________________________________ 6-60
Sending the Track Information______________________________________________________ 6-61
Reviewing the ASCII Code and Character Table________________________________________ 6-62
Using the Lamination tab (only with Card Lamination Module) ______________________________ 6-63
Selecting the Lamination Position ___________________________________________________ 6-64
Selecting the Lamination Side ______________________________________________________ 6-65
Selecting the Lamination Type______________________________________________________ 6-66
Adjusting the Transfer Dwell Time and Transfer Temperature _____________________________ 6-68
Selecting Default button___________________________________________________________ 6-68
Using the Overlay/Print Area tab ______________________________________________________ 6-69
Using the Overlay/Print Area dropdown menu _________________________________________ 6-70
Using the Overlay/Print Area radio buttons ____________________________________________ 6-71
Using Security Options (Visual Security Solutions)______________________________________ 6-77
Selecting Orientation - Landscape under Card tab _______________________________________ 6-78
Selecting the Visual Security Solutions dropdown menu (A to D) __________________________ 6-79
Selecting Orientation - Portrait under Card tab _________________________________________ 6-80
Selecting the Visual Security Solutions dropdown menu (E to H)___________________________ 6-81
Selecting the VeriMark radio button _________________________________________________ 6-82
Selecting the HoloMark radio button _________________________________________________ 6-83
Reviewing the Custom VeriMark and HoloMark Cards __________________________________ 6-84
Reviewing the Custom HoloMark Card _______________________________________________ 6-85
Using the K Panel Resin tab __________________________________________________________ 6-86
Selecting the Full Card with the K Panel Resin tab ______________________________________ 6-87
Selecting the Defined Area(s) with the K Panel Resin tab_________________________________ 6-88
Selecting the Undefined Area(s) with the K Panel Resin tab _______________________________ 6-89
Defining the Area to activate the Card Grid____________________________________________ 6-90
Measuring the Total Card area ______________________________________________________ 6-91
Defining the positioning of the area on the Card ________________________________________ 6-93
Selecting the Print YMC under the K and Print K Only options ____________________________ 6-95
Using the Printer Supplies tab_________________________________________________________ 6-97
Reviewing the Ribbon Information __________________________________________________ 6-98
Reviewing the Ribbon Level Indicator________________________________________________ 6-99
Section 7: Ethernet Option Section ___________________________________________7-1
Introduction________________________________________________________________________ 7-1
Technical Specification - Ethernet Option ________________________________________________ 7-2
Functional Specification - Ethernet Option________________________________________________ 7-3
Network Services - Overview ____________________________________________________7-4
Reviewing the Print Server__________________________________________________________ 7-4
Reviewing the Web Page Server _____________________________________________________ 7-4
Reviewing the Network Management Interface __________________________________________ 7-4

Fargo DTC550 Specifications

General

Brand	Fargo
Model	DTC550
Category	Printer
Language	English