Executing Calibration
99
Maintenance
3
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID
with the numeric keypad or the keyboard
displayed on the screen, and select
[Enter].
When a passcode is required, select [Next]
and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home]
screen.
Note • When the [Services Home] screen is not
displayed on the touch screen, press the
<Services Home> button.
4) Select [System Settings] > [Common
Service Settings] > [Image Quality
Adjustment].
2 Select [Calibration].
3 Set [Screen Type] and [Paper Supply].
Note • The following describes calibration
procedures using Copy Job 2, as an
example.
• For [Paper Supply], select the paper tray in which A4 , A3 , 8.5 x 11" , or 11 x 17"
white paper is loaded.
<Log In/Out> button
To Next Page
Loading...
