Faxing 296
2-Sided Print You can set whether to make duplex print when you print
faxes.
Select Off to print faxes on one side of a sheet of paper.
Select On to print faxes on both sides of a sheet of paper.
Sent Fax Fwd You can set your printer to forward incoming faxes to another
fax number. When a fax arrives at your printer, it is stored in
the memory. Then, the printer dials the fax number that you
have specified and sends the fax.
Select Off not to forward incoming faxes.
Select Forward to forward incoming faxes without printing. If
an error occurs during forwarding a received fax, the printer
prints the fax.
Select Print & Forward to forward and print incoming
faxes.
Fwd. Settings Num You enter the fax number of the destination to which incoming
faxes will be forwarded.
Prefix Dial You can specify whether or not to set a prefix dial number.
Prefix Dial Num You can set a prefix dial number of up to five digits. This
number dials before any auto dial number is started. It is
useful for accessing the Private Automatic Branch Exchange
(PBX).
Discard Size When receiving a document as long as or longer than the
paper installed in your printer, you can set the printer to
discard any excess at the bottom of the page. If the received
page is outside the margin you set, it will print on two sheets of
paper at the actual size. When the document is within the
margin and Discard Size is set to Auto Reduction, the
printer reduces the document to fit it onto the appropriate
sized paper and discard does not occur. If Discard Size is
set to other than Auto Reduction, the data within the
margin will be discarded.
ECM You can set whether to enable or disable the ECM (Error
Correction Mode).
Extel Hook Thresh You can select the external telephone hook detection
threshold for the condition in which a telephone line is not
being used.
Modem Speed You can set the modem speed.
Country You can select the country where the printer is used.
You can change this setting when:
• No jobs in operation
• No fax jobs waiting in the memory
Fax Activity You can set whether to automatically print a fax activity report
after every 50 incoming and outgoing fax communications.
Fax Transmit You can set whether to print a transmission result after a fax
transmission.
Fax Broadcast You can set whether to print a transmission result after a fax
broadcast to multiple locations.
Fax Protocol You can set whether to print the protocol monitor report after a
fax transmission to monitor fax protocol problems.
Option Description
To Next Page
Loading...
Need help?
General
