154 KAYENNE — User Manual
Section 3 — System Operation
3. In the Create Show pane, touch to select/deselect file types, or touch
the
Select All button (e-DPM is an option, if not installed the button will
be inactive).
4. Select the register data pad (left of each button) and enter a series or
range of registers to be included in the Show file (the default is
all).
5. Touch the Create button in the Create Show pane.
Choose Load
Pressing Choose Load brings up a pane that allows you to see what files are
contained in the Show, and select which files to load. Buttons for files not
present are grayed out. By default all the files in the Show are selected for
load. The controls in this pane operate the same as the Create Show, except
the
Load button replaces the Create button.
Specify the file types and ranges of files you wish to load, then touch the
Load button.
Update Show
Touching the Update Show button brings up a pane that allows you to select
specific files within a show to update. Specify the file types and ranges of
files you wish to update, then touch the
Update button. The selected files in
the show will be overwritten with the current Kayenne settings for those
items.
Load Show
Touching the Load Show button immediately loads all the files in the cur-
rently selected show into the Kayenne system. This operation will over-
write the existing settings that are currently being used. While the current
work buffer and video outputs will not be affected, other aspects of system
operation (source mapping, source name displays, available effects, etc.)
will change depending on what files are being loaded.
CAUTION Be sure the Show contains appropriate files before you load a Show, espe-
cially if the system is currently on-air or the Show contains Eng Setup files.
Choose Load can be used to inspect the Show and select files before loading.
All Files Operations
The File Operations All Files menu is used for managing Kayenne system
file storage. The menu is accessed from
File Ops, All Files (Figure 108).
To Next Page
Loading...
Need help?
General
