258 KAYENNE — User Manual
Section 3 — System Operation
Source Ops from the Control Panel
Assigning Sources
To assign sources to an eDPM output (eDA, eDB, eDC, or eDD):
1. Press the eDPM channel input destination button (see Aux Delegation
on page 255) on the Local Aux Module (or ME delegated as Aux).
2. Press the source select button with the source for the eDPM on the Local
Aux Module (or delegated ME).
3. Repeat steps 1 and 2 for up to four eDPM sources.
Split Key
From the Local Aux Module, a split key can be performed to select the cut
signal. When selecting sources into the eDPM channels, both the video and
key (cut) signals are changed at the same time. The Local Aux Module pro
-
vides a Key Split button to independently select the key (cut) signal.
1. Select a video source.
2. Hold down the Key Split button and select the desired key source.
3. Release the Key Split button.
The control panel will display the currently selected video source. Press the
Key Split button at any time to verify the key (cut) signal.
Button Mapping eDPMs to an ME
Map the eDPM outputs to the source select buttons on the MEs in the User
Setups, Panel Prefs, Button Mapping menu (see
Button Mapping on
page 125).
Note eDPM sources are identified as eDA, eDB, eDC, and eDD and all have a cor-
responding key (cut) signal already associated with those outputs, therefore
the key signal outputs of the eDPM channels do not need to be mapped on
the switcher for normal operations.
eDPMs and the MFM
Parameter controls (joystick and buttons) work very similarly to that of
iDPM in the MFM (see
Parameter and Soft Knob Controls on page 207).
Many of the same controls as in the Menu Panel are available in the MFM.
From the Home menu, press the eDPM soft button. eDPM Channels 1-4 can
To Next Page
Loading...
