KAYENNE — User Manual 89
Control Panel Overview
Module Overview
An ME Stripe has a module for source selection, transition, and individual
E-MEM control (
Figure 68). Additional Master E-MEM, Device Control
(optional), Multi-Function, and Local Aux modules are populated to com-
plete the control surface functionality. System operation information and
procedures will be covered more thoroughly later in this chapter.
Figure 68. Portion of Control Panel ME Stripe
Transition Module
The Transition Module is organized into two control groups, the main tran-
sition controls, with status display and transition lever arm, and Keyer
transition controls (
Figure 69). For information about using transitions, see
Transitions on page 161.
Main Transition controls:
• Lever Arm—For manual transitions
• Status Display—Displays bus and keyer delegation and status
• Next Transition Element buttons
• Next Transition Type buttons
• Cut/Auto Transition buttons with Trans Rate display
• Transition Preview and Preset Black buttons
Keyer transition controls:
• K1-K6 (Keyer) Cut buttons
• K1-K6 Auto Transition buttons
HoldHold
HoldHold
A
HoldHold
B
U1
U2
HoldHold
FarFarKeyKey
SplSplit
RulesRules
HoldHold
EMEMEMEM
SecSec
Aux
Pri
KeyKey
3
KeyKey
1
MacroMacro
KeyKey
5
KeyKey
4
KeyKey
2
RtrKeKey
6
EMEMEMEM
MaMacroro
RevRev
RwdRwd
RunRun
Transans
RateRate
Auto
Run
Run
Panelnel
MemMem
MeMenu
Mix
Transns
PVW
Transans
Rate
EMEMEMEM
Runun
Ptntn
LimLimi t
Pst
BLK
KeyKey
1
KeyKey
2
KeyKey
3
KeyKey
4
KeyKey
5
KeyKey
6
KeKey 1
CutCut
KeKey 2
CutCut
KeKey 4
CutCut
KeKey 3
CutCut
KeKey 6
CutCut
KeKey 5
CutCut
KeKey 1
Auto
Auto
KeKey 2
Auto
Auto
KeKey 3
Auto
Auto
KeKey 4
Auto
Auto
KeKey 6
Auto
Auto
CutCut AutoAuto
KeKey 5
Auto
Auto
Userer
5
Userer
6
Userer
4
Wipeipe
2
Wipeipe
1
Userer
3
Userer
2
Userer
1
Key
Prior
8623266_54
Source Module (35, 25, or 15) Local E-MEM ModuleTransition Module
To Next Page
Loading...
Need help?
General
