174 KAYENNE — User Manual
Section 3 — System Operation
Recalling Registers
The Kayenne system is optimized for rapid effects recall, generally accom-
plished with a single keystroke.
Note If recalling effects from the Master E-MEM Module with Auto Recall off, you
first need to specify which levels you wish to control with the Enable buttons.
Recall a Register in the Current Bank
1. Press the E-MEM module keypad number of the desired register.
Recall a Register from a Different Bank
1. Press the Page button (if necessary).
2. Press the button for the desired page: 0, 100-900.
3. Press the BNK button.
4. Press the button of the desired bank.
5. Press the keypad button of the desired E-MEM register.
Alternatively, you can perform the Bank, then Page selections, then press
the desired register button.
Clearing Registers
When you build an effect you may want to start with an empty register.
This can be done in the E-MEM & Timeline, Register Ops menu.
To Clear the Current Register
1. Touch the Clear Current Reg button, bottom left of the keypad (lower right
of menu).
To Clear a Different Register
1. Touch the Clear button (left side of menu).
2. Using the keypad, enter the register number to be cleared and touch
Enter.
To Next Page
Loading...
Need help?
General
