158 KAYENNE — User Manual
Section 3 — System Operation
Each menu is similar to the other File Ops menus with a file display pane
on the left and the same navigation and action buttons in the center.
Each menu provides the Utilities pane (Copy, Paste, etc.) and the ability to
select all, individual, or a range of register files to be saved or loaded. In
addition, in the File Operations pane, you can enter a starting register
which allows you to save/load a register or range of registers to a different
register or range of registers.
To Save Register Files:
1. Navigate to the desired destination directory and/or create a new
folder for the file using the buttons in the File Operations pane.
2. Touch one of the three Save/Load Register mode buttons (center) and
a. Touch the All button to select all register files, or
b. Touch the Enter Reg(s) button then enter a register or range of
registers in the
Register data pad (right), for example 1-5,10,12, or
c. Touch the Select Reg(s) button then select register files in the file
display panel (touch
Multi-Select button for multiple selections).
3. Touch Save. The register or range of registers will be saved to the target
directory.
To Load Register Files:
Registers are loaded by using the same methods as above but by touching
the
Load button.
Loading to a Different Set of Registers
One additional method of loading registers is available, that permits
loading registers with an offset.
1. Navigate to the desired destination directory and/or create a new
folder for the file using the buttons in the File Operations pane.
2. Touch the Enter Reg(s) button then enter a register or range of registers in
the
Register data pad (right).
3. Touch the Start Register (highlights green) button.
4. Enter the number of the first register into which you wish to load the
selected range of registers, then touch
Enter.
5. Touch the Load button.
The range of registers will be loaded to the specified register number
shown in the
Register data pad.
To Next Page
Loading...
Need help?
General
