GRASS VALLEY KAYENNE - V2.0 User Manual

322 KAYENNE — User Manual
Section 3 — System Operation
Figure 211. DCM—Q-MEMs
Learning a Q-MEM Register with a Single Device
To learn a simple cue with one device (see Figure 211):
1. Select a device by pressing a control button, A - F.
2. Select a clip on that device using the bottom soft knob and press the Load
button to load the clip. You can then set the mark-in/mark-out points
(
Mark In/Mark Out buttons) and optionally turn on the Loop button (tallies
blue).
3. Press the LRN button.
a. Optionally, press the Play button (flashes green) to add a play
command (so when the cue register is recalled, the clip will load and
play).
4. Press the desired Cue register number button (use the Page and Bank
buttons for the higher numbered registers). The selected Cue register
button high tallies red.
Learning a Q-MEM Register with Multiple Devices
Learning Devices with Letter Buttons
Lettered button (A - F) links can be learned as part of a Cue register for later
recall:
1. Press and hold down the letter buttons for the devices to be linked (for
example A, B, and D).
Go To
TCTC
Mark
In
In
LinkLink
CueCue
SetSet
InIn
Mark
Out
Out
SetSet
OutOut
CueCue
Load
LoopLoop
Var
ShShutl
A B C D E F
GV/BrightStar
I
ØØ:ØØ:ØØ:22 OU ØØ:ØØ:Ø7:24
D ØØ:ØØ:Ø7:Ø2 TC ØØ:ØØ:ØØ:ØØ
CS-1
12
345
MISC4
LRN 9 8 7
SDEL 6 5 4
PAGE 3 2 1
BANK 0
8623267_12_r1

GRASS VALLEY KAYENNE - V2.0 Specifications

General

Brand	GRASS VALLEY
Model	KAYENNE - V2.0
Category	Recording Equipment
Language	English