208 KAYENNE — User Manual
Section 3 — System Operation
Note The X and Y modifiers are changing the same as the X and Y values for 3dLc.
• 3dLc — X, Y, and Z 3D Locate
•
ROT — Rotate
•
SPIN — Spin
•
Axis — Locate Axis
•
ASPT — Aspect
•
SKEW — Skew
•
PRSP — Perspective
•
2DLc — Post Transform (X, Y, and Z locate in 2D space)
The PGLB (Primary Global) and SGLB (Secondary Global) buttons available
in the iDPM Mode in the MFM activate keyers delegated to Primary and
Secondary Global Channels (iDPM Keyer delegations can only be made in
the Menu Panel).
Note The SGLB button will only be available if the ME has been split.
For the CROP, SHAD, FILM, and FRZ buttons, DELG must be pressed below each
to delegate the MFM to those functions.
Transform Menu
Note Controls for the standard Shadow and Glow features are available without
iDPM options in the Borderline menu (see Borderlin e Menu on page 226).
An iDPM activated in a keyer can be controlled with the Transform menu.
The Transform menu allows you to select the keyer or Global channel to
control (delegation), select the desired type of transform control, and then
adjust the parameters associated with the chosen control using the soft
knobs or a pop-up keypad. The menu is accessed by touching
iDPM, Trans-
form (Figure 138).
To Next Page
Loading...
