302 KAYENNE — User Manual
Section 3 — System Operation
To change the source table for the bus link:
Touch the Linked bus data pad in the Link Setup menu, Current Link pane,
for the bus link you wish to change the Source Table. The Source Tables
column becomes available. Touch another source table for the bus link.
Source Table File Operations
Source Tables are part of Kayenne file operations: File Ops, Source
Tables menu. You can perform all the same file operations: copy, paste,
save, load, etc., as with other File Ops menus. For more about File Oper
-
ations, see File Operations on page 149.
Linking Busses
Linking Busses one-to-one
1. In the Links Setup menu, touch the Controlling Bus data pad.
2. Touch the ME/Aux/eDPM menu tab.
3. Touch the desired bus or eDPM input.
4. Touch the Linked Bus data pad and repeat Steps 1-3.
The Link Setup menu displays the newly linked busses in the Current
Link pane. The link is enabled and the Standard Source Table is selected
as the default (Source Tables are grayed out).
You can disable or break the link using the Enable/Break buttons in the
Current Link pane (the
Enable button in the Table Setup pane will also
enable/disable the selected link).