KAYENNE — User Manual 175
E-MEM Operations
To Run an Effect
With Auto Run Off
1. Recall the desired effect.
2. Press Run.
With Auto Run On
1. Recall the desired effect. The effect will run as soon as it is recalled.
E-MEM Sequences
To Learn a Sequence of Registers
1. Press LRN, SEQ.
2. Press the page, bank, and register keypad buttons of the desired
registers in the order you wish them to run. Delay time can be added at
each register by pressing
Trans Rate and entering a time value.
3. Press LRN.
To Play a Sequence of Registers
1. Press SEQ.
2. Press the page, bank, and register keypad button of the starting register.
To Break a Sequence
1. Press LRN, SEQ.
2. Press the page, bank, and register keypad button of the register to end
the sequence.
3. Press the same page, bank, and register button a second time.
Basic Effect Editing
Effect editing involves changing work buffer values using panel and/or
menu controls, then applying these values to the effect. This discussion
concerns basic effect editing, using the Master Timeline for the examples.