188 KAYENNE — User Manual
Section 3 — System Operation
There are several ways to change an effect so moves begin and end without
any windup.
• Change the Path Type on the function keyframe to S-Linear.
• Set the Curve path Tension value on the function keyframe to 100.
• Set a Path Control menu Hold for the function on the previous key-
frame.
E-MEM Transitions
Transitions can be built into E-MEM resisters. Recalling and running these
E-MEMs will make the transitions occur as programmed. The lengths of
transitions in effects is determined by keyframe duration, not the transition
duration used for manual transitions. When you build effects with transi
-
tions, keep the E-MEM transition rules in mind, which are different from
the rules used for manual transitions. The beginning and ending states of
the buses and transition elements must be set properly.
Though background and keyer transitions are described here as separate
procedures, effects can easily be built that include both background and
key transitions in the same keyframe by selecting the appropriate next tran
-
sition element buttons.
E-MEM Transition Rules
New with Kayenne 2.0, Key Priority Transitions interpolate wipes and
mixes as part of an E-MEM.
Note When creating a priority transition that will interpolate as part of an E-MEM,
it will only transition correctly if the ‘Next’ Priority Stack on the initial key-
frame is set to match the ‘Current’ Priority Stack of the subsequent keyframe.
• A background transition will occur only when the Bkgd next transition
element is selected on the initial keyframe AND the source selected on
the B bus of the initial keyframe matches the source selected on the A
bus of the following keyframe.