392 KAYENNE — User Manual
Section 3 — System Operation
3. Determine where you want a mark-in point for the Video track by
either playing/jogging to the mark while viewing the clip on a monitor
and touching the
Mark In button (Figure 243) or if you know the
timecode, touch the Mark In data pad and enter the timecode into the
pop-up keypad, and touch
Enter.
4. Determine the mark-out point for the Video track and enter it as
described for Mark In.
5. Turn off the Use Audio From Video button (Audio section) by touching it
(
Figure 243).
6. Touch the Audio Thumbnail Viewer.
7. Touch the Change Clip button and touch the desired clip/.WAV file with
the desired Audio track.
8. Synchronize the Audio track in relation to the current video track
timecode position, if needed, using the
Hold Sync data pad or the Audio
Offset
soft knob (see page 388 for more about Hold Sync).
With the Video Thumbnail Viewer selected, you can test the composite elements
using the motion control buttons.
Make the Sub-clip
1. Touch the Make Clip button.
2. Enter the name of the new clip and touch Enter.
Add/Replace a Key Element with Build Edit—In this case, you want to use the
video and audio of the loaded video element but add/replace the key track
and make a sub-clip. The
Use Audio From Video button is enabled (highlighted
green):
1. Unless the desired clip is loaded, touch the Video thumbnail viewer
(
Figure 244).
To Next Page
Loading...
