400 KAYENNE — User Manual
Section 3 — System Operation
Image captures can be performed as a video, key (see Key Signal-only
Capture on page 406), or a video/key pair. Odd numbered channels can
output video only but even numbered channels can output both video and
key. A key-only capture means adding a key to an existing video.
To capture stills, perform the following:
1. Setup the input sources on the Local Aux Module (see Image Store Input
Aux Delegate Mapping on page 397).
2. Go to the Capture Still menu by touching Image Store, Replay & Record, Still
menu tab.
Figure 249. Capture Still Menu
3. Select an Image Store channel by touching it (1-6 under ‘Program’).
To Next Page
Loading...
