KAYENNE — User Manual 407
Image Store (Stills)
Figure 256. Source Ops, Quick Tab Menu
Using the Key not Video button changes an input source to a separate
(unpaired) key signal.
1. Go to the Source Ops, Image Store menu by touching Source Ops, Image
Store
.
2. Touch the even numbered Image Store channel you want to record as a
key.
3. Touch the corresponding Key Not Video button.
4. Using the Source scroll list, touch to select the desired source for the key.
Any change to Image Store channels in this way will be reflected in the
Image Store, Replay & Record, Stills menu tab.
5. Press the Capture Still button.
6. Verify that the channel defined as “Video Not Key” is selected.
7. Capture the key signal for that channel (see Capturing a Still from Input
Video on page 399), or pair and capture the key signal with an odd
channel (see Capturing Stills as Video Key Pairs on page 403).
Note If a linear key has been assigned in Eng Setup, that key will be captured but
if no key was assigned, the key will be full raster white.
To Next Page
Loading...
