GW Instek MFG-2000 Series - Page 366

MFG-2000 Series User Manual
366
-221 Settings conflict; infinite burst changed trigger source to MANual
Example: The trigger source is changed to
immediate from manual when infinite burst mode is
selected.
-221 Settings conflict; burst period increased to fit entire burst
Example: The function generator automatically
increases the burst period to allow for the burst
count or frequency.
-221 Settings conflict; burst count reduced
Example: The burst count is reduced to allow for the
waveform frequency if the burst period is at it’s
maximum.
-221 Settings conflict; trigger delay reduced to fit entire burst
Example: The trigger delay is reduced to allow the
current period and burst count.
-221 Settings conflict;triggered burst not available for noise
Example: Triggered burst cannot be used with noise.
-221 Settings conflict;amplitude units changed to Vpp due to high-Z load
Example: If a high impedance load is used, dBm
units cannot be used. The units are automatically set
to Vpp.
-221 Settings conflict;trigger output disabled by trigger external
Example: The trigger output terminal is disabled
when an external trigger source is selected.
-221 Settings conflict;trigger output connector used by FSK
Example: The trigger output terminal cannot be used
in FSK mode.
-221 Settings conflict;trigger output connector used by burst gate
Example: The trigger output terminal cannot be used
in gated burst mode.