GW Instek MFG-2000 Series - Page 367

REMOTE INTERFACE
367
-221 Settings conflict;trigger output connector used by trigger external
Example: The trigger output connector is disabled
when the trigger source is set to external.
-221 Settings conflict;frequency reduced for pulse function
Example: When the function is changed to pulse, the
output frequency is automatically reduced if over
range.
-221 Settings conflict;frequency reduced for ramp function
Example: When the function is changed to ramp, the
output frequency is automatically reduced if over
range.
-221 Settings conflict;frequency made compatible with burst mode
Example: When the function is changed to burst, the
output frequency is automatically adjusted if over
range.
-221 Settings conflict;frequency made compatible with FM
Example: When the function is changed to FM, the
frequency is automatically adjusted to suit the FM
settings.
-221 Settings conflict;burst turned off by selection of other mode or
modulation
Example: Burst mode is disabled when sweep or a
modulation mode is enabled.
-221 Settings conflict;FSK turned off by selection of other mode or
modulation
Example: FSK mode is disabled when burst, sweep
or a modulation mode is enabled.
-221 Settings conflict;FM turned off by selection of other mode or
modulation
Example: FM mode is disabled when burst, sweep or
a modulation mode is enabled.