GW Instek PEL-2000A Series - Programming

PEL-2000A Series User Manual
108
Programming
When creating a Program Sequence or Chain, all channels are used
at the same time unless programmed otherwise. Program
Sequences use the channel settings stored from Memory Data.
Program sequences are primarily used to perform a battery of
pass/fail tests on DUTs.
DUT
Step
Description
Details
1. Setup
Choose the appropriate load
module(s).
Page 38
2. Connection
Connect the terminals to the DUT.
Page 45
3. Channel
selection
Select the load channel(s) on the
mainframe.
Page 126
4. Channel
setup
See the “Single channel load”
tutorial to configure a single
channel. Do not activate the load.
Page 104
5. Save channel
Save the configured channel.
Page 238
6. Multiple
channels
If multiple channels need to be
configured, follow steps 1-5 for
any remaining channels.
7. Program
menu
Enter the Program menu.
Page 151
8. Configure the
sequence
Configure the program.
9. Save
sequences
Save the Program in the FUNC
Program menu.
10. Program
Chains
If required, Program chains can be
created.
Page 155