GW Instek PEL-2000A Series - Configuring USB Connection

OPERATION
233
3. If the Interface mode is not
RS232, use the Selector knob to
edit Interface.
4. Choose RS232.
O
Interface
RS232
5. Press the Selector knob to
confirm.
OR
ENTER
6. The RS232 Menu appears.
O
RS232
Interface
ConfigureOtherInterfaceLoad
Baud rate
Stop Bit
Parity
38400
1
None
LOAD
RS232
Time Set
System
Info
06/15/18
16 : 50
7. Use the Selector knob to edit
Baud rate, Stop Bit and Parity.
Note
The Baud Rate, Stop Bit and Parity must match that of
the host machine.
For RS232 function check, please refer to the section
“RS232 and USB CDC function check” on page 238.
Configuring USB Connection
Background
Of the three interface options, USB is the easiest to
use.
USB connection
PC side connection
Type A, host