OPERATION
157
7. Repeat the above procedure to P02~P12 to
complete the program chain.
The Program Chain ends at the first Program (PXX)
that is followed by Off. It is possible to create
continuously looping program chains.
8. Press F3 (Save) to save the
program chain.
Note the Program Chain data is not yet saved into
Setup Memory. If you wish to save the Program Chain
to Setup Memory see page 246.
9. To recall the Default program
chain, press F4.
If the Default is recalled, Start will revert to P01 and
all program sequences will be set to Off.
10. Press F5 (Previous Menu) to
return the Sequence menu.
Running a Program
Once a Program Chain/Program Sequence has
been created, it can be executed. As Program
Sequences apply to all the channels, any channels
that don’t need to be active (load off) can be
programmed in the Active Channel menu. At
Default, all channels are set to (load) Off.
EXT will be shown next to any channels set to
external channel control.
1. Create 1 or more Program
Sequences.
2. Create a Program Chain.
To Next Page
Loading...
