When SPEC test is set to ON, SPEC
will be displayed in the Current
Operation Channel Status panel.
The Group Unit menu allows load modules of the
same type and rating to be configured as a single
unit when used in parallel. Up to 4 load modules
can be used in this mode.
Operating the PEL-2000A series load modules in
Group Unit mode is almost identical to using the
load modules separately. The only difference is
that the channel configuration only needs to be
setup for channel 1 and not individually for each
channel.
There are two mode types: Para and Sync. The
Para setting allows the all the parallelized load
modules to be operated as a single large load
module. Sync mode allows the settings of a single
unit to be synchronized across all the other
parallelized load modules.
The Display Mode will determine which
parameters are displayed on the local load
modules.
To Next Page
Loading...
