GW Instek PEL-2000A Series - Local Mode Operation; Selecting a Channel

PEL-2000A Series User Manual
120
Local Mode Operation
Each channel can be edited by its local load module. Depending on
the configuration, local changes can be reflected on the mainframe.
For this section all operations refer to knobs and buttons on the
local load module panels, unless stated otherwise.
Selecting a Channel
Background
Each channel can be individually selected by
using its load module panel. Changing channels
on a load module only applies to dual channel
load modules.
Single Channel
Panel operation
Press any key on a load module to
select its channel.
Dual Channel
Panel Operation
For dual channel load modules,
press any key on a load module that
has the desired channel. Press the
R/L key to cycle between the
channels on the load module. L or R
will be displayed on the bottom left
hand to indicate which channel (left
or right side) is active on the load
module.
R / L
Note
On single channel modules, pressing the A/B key
repeatedly will change the level from A or B when in
Static mode.
Channels cannot be selected in Group Unit Mode.