GW Instek PEL-2000A Series - Configuring the Load Delay Time

OPERATION
195
Note
When a channel has been set to
independent, an asterisk (*) will be
shown next to the channel number
indicator in the Current Operation
Channel Status panel.
The configuration settings only apply to
the current channel, other channels will
not be affected.
*CH1
conf
CCDH
80V
Configuring the Load Delay Time
Background
The mainframe can delay loading a channel by up
to 10 seconds. However the Delay Time is only
applicable for manual loading. Delay Time is not
applicable to Programs or Sequences.
Parameter
Load D-Time
0~10 S
Panel operation
Ensure the menu is the configuration menu. See
page 180.
Configure
Previous
Menu
Protection
Go-NoGoOther Group
1. Press the F2 (Other) key to enter
the other menu.
F2