GW Instek PEL-2000A Series - Select CC Static Mode; Editing CC Static Parameters

PEL-2000A Series User Manual
132
Select CC Static Mode
Background
Constant current mode can be set to dynamic or
static mode. Static mode is for manually varying
the load for single channel load modules or to set
a static load on dual channel modules.
Ensure the menu is in CC Mode. See page 127.
ConfigureConfigure
Mode
CC
Dynamic
Range
High
Panel Operation
1. Press the F3 key until Static mode
is selected.
Dynamic
Static
F3
Note
Changing from static to dynamic mode will only affect
the current (active) channel.
Editing CC Static Parameters
CC Values
When using a single channel load module, Static
Constant Current Mode has two operating current
values, A&B. If a dual channel load is used, only
one current value is available per channel:
A Value.
If Group Unit Mode is enabled, an additional
parameter, Switch Value, is available to switch
from A Value to B Value.
Ensure the menu is in CC Static Mode. See page
132.
ConfigureConfigure
Mode
CC
Static
Range
High
Seq.
Edit