PEL-2000A Series User Manual
282
Configure GPIB interface
The interface function codes for the Electronic
Load are listed as the following table.
Source Handshake capability
Acceptor Handshake capability
Talker (basic talker, serial poll, unaddressed
to talk on LAG)
Listener (basic listener, unaddressed to
listen on LAG)
Service Request capability
No Remote/Local capability
No Parallel Poll capability
No Device Trigger capability
Open collector bus drivers
No Extended Talker capability
No Extended Listener capability
Connect the GPIB cable to the
rear panel port: 24-pin female
connector.
To Next Page
Loading...
