GW Instek PEL-2000A Series - Adjusting the von Latch Clear

OPERATION
225
Adjusting the Von Latch Clear
Background
Auto: Load starts when the terminal voltage of
module is higher than Von value. The system
stops loading when the terminal voltage of
module is close to 0V for more than 25ms and
system is under the state of detecting Von again.
Manual: The load starts when the terminal voltage
of module exceeds the Von setting value. Loading
keep going even if the terminal voltage of module
close to 0V.
time
Von
Von Latch: ON
Von Latch Clear: ON
load
Output
PEL-2000A
Load
V
I
25ms
time
time
Von
Von Latch: ON
Von Latch Clear: OFF
load
Output
PEL-2000A
Load
V
I
time