GW Instek PEL-2000A Series - Peration; Default Chapter; Operation

OPERATION
117
OPERATION
The PEL-2000A series operation is described in the chapters below.
The sections are broken down into small operations. For thorough
examples on the operation of the load, please see the tutorial
section on page 102.
Local Mode Operation ........................................ 120
Selecting a Channel....................................................... 120
Selecting Static/Dynamic .............................................. 121
Turning on the Load ..................................................... 122
Shorting ......................................................................... 123
Display Output View ..................................................... 123
Editing CC/CR/CV/CP A/B Value ................................. 124
Mainframe Basic Operation ................................ 126
Help Menu .................................................................... 126
Channel Selection ......................................................... 127
Select CC Mode ............................................................. 128
Select CC Range ............................................................ 128
Select CC Dynamic Mode ............................................. 129
Editing CC Dynamic Parameters .................................. 130
Select CC Static Mode................................................... 132
Editing CC Static Parameters........................................ 132
Set to CR Mode ............................................................. 134
Select CR Range ............................................................ 135
Select CR Dynamic Mode ............................................. 136
Editing CR Dynamic Parameters .................................. 136
Select CR Static Mode ................................................... 139
Editing CR Static Parameters ........................................ 139
Select CV Mode ............................................................. 141
Editing CV Parameters .................................................. 142
Select CV Range ............................................................ 144
Select CV Response Speed ........................................... 144
Select CP Mode ............................................................. 145
Editing CP Parameters .................................................. 146