GW Instek PEL-2000A Series - Editing CC;CR;CV;CP A;B Value

PEL-2000A Series User Manual
124
Voltage
Current
Power
Load on time.
Note
The Display mode cannot be changed in Group Unit
mode.
Editing CC/CR/CV/CP A/B Value
Background
The Slave Knob is used to edit the A Value or B
Value (single channel load module) when in static
mode. The Slave Knob can also operate in fine or
coarse editing mode.
Panel Operation
1. Ensure the mode is in static
mode.
Page 121
2. Choose a channel (or choose A
or B Value) by pressing the R/L
or A/B key.
R / L
3. Press the Slave Knob to toggle
between fine and coarse editing
mode.
SEt_C = coarse mode.
SEt_F = fine mode.
Fine mode example:
Coarse mode example:
4. Turn the Slave Knob to edit the
A/B Value for the selected
mode.