The rising and falling slew rate (A/uS) determines
the speed at which the load levels change from A
to B Value (Static mode) or from Level1 to 2
(Dynamic mode) and vice versa.
Go/NoGo is also supported. Center, High and
Low limits can be set as either percentages or
voltage values. A delay time of up to 1 second can
also be set.
In Constant Voltage Mode the load units will sink
current whilst keeping the voltage constant.
Single channel load modules support 2 values (A
Value, B Value) and have an adjustable cut-off
current limit. Dual channel load modules only
have A value.
Response speed can also be set to fast (Fast) or
slow (Slow). The response speed relates to the
slew rate of the current response.
Go/NoGo functionality is also supported either as
a percentage or as a current value.
To Next Page
Loading...
