GW Instek PEL-2000A Series - Adjusting the Jog Shuttle Control

PEL-2000A Series User Manual
228
5. Press the Selector Knob or Enter
to confirm selection.
OR
ENTER
Adjusting the Jog Shuttle Control
Background
ON: After this setting is enabled, the settings
value will be adjusted by slave knob in Jog Shuttle
mode when you adjust the setting value. The
interval value is adjusted according to the knob
speed.
OFF: If this setting is disabled, the settings value
will be adjusted by slave knob in the form of fixed
compartment when you adjust the setting value.
Parameter
Jog Shuttle Control
ON/OFF
Panel operation
1. Press the Shift Key then the Help
key to access the Utility menu.
UTILITY
HELP
SHIFT
2. Press F5 (Other Menu).
F5
ConfigureOther
Other Setting
High Resolution
System Mode
Von Latch Clear
Measure Period
Jog Shuttle Control
ON
0
Auto
200ms
OFF
Load Interface
LOAD
USB
Time Set
System
Info
06/15/18
16 : 50
3. Use the selector knob to
highlight Jog Shuttle Control