GW Instek PEL-2000A Series - Single Channel Load

PEL-2000A Series User Manual
104
Single Channel Load
Single channel loads are used to manually test a DUT quickly or to
configure channel settings for Program Sequences using the
mainframe panel.
DUT
Step
Description
Details
1. Setup
Choose the appropriate load
module and make sure it is
installed.
Page 38
2. Connection
Connect the terminals to the DUT.
Page 45
3. Channel
selection
Select the load channel on the
mainframe.
Page 126
4. Measurement
mode
selection
Select measurement mode (CC,
CV, CR, CP).
CC Page 128
CV Page 141
CR Page 134
CP Page 145
5. Range
selection
Set the range to high or low (CC,
CR, CV and CP mode).
CC Page 128
CR Page 135
CP Page 148
6. Mode
selection
Choose Static or Dynamic mode
(CC & CR mode only).
CC Pages
129, 132
CR Pages 136,
139
7. Dynamic
levels
(CC,CR)
Set the dynamic levels, slew rate
and timers. Applicable to CC &
CR mode only.
CC Page 130
CR Page 136