GW Instek PEL-2000A Series - Select CC Mode; Select CC Range

PEL-2000A Series User Manual
128
Select CC Mode
Background
The PEL-2000A series loads operate in four
different modes: Constant Current (CC), Constant
Resistance (CR), Constant Voltage (CV), and
Constant Power (CP).
When a channel is active, the F1
key can be used to switch
between each operating mode.
F1
Mode
CC
Mode
CR
Mode
CV
Mode
CP
Panel Operation
1. Select a channel using the
CHAN button and selector knob.
LOCAL
CHAN
2. Press F1 repeatedly until CC
mode is displayed in the display
panel.
F1
ConfigureConfigure
Mode
CC
Dynamic
Range
High
Changing the operating mode will only affect the
current (active) channel. Other channels will not be
affected by any changes.
Select CC Range
Background
Constant current mode can run in high and low
range. Maximum range is dependent on the load
module. Some models are only high range.
Ensure the menu is in CC Mode. See page 128.
ConfigureConfigure
Mode
CC
Dynamic
Range
High