GW Instek PEL-2000A Series - General Configuration Options

TUTORIALS
115
General Configuration Options
There are number of different options for each channel. The
different options are described below.
Options
Description
Details
1. CC Vrange
Configure the CC Voltage range
from high or low.
Page 185
2. Von Voltage
Configure the Von Voltage settings.
Page 187
3. Short
Settings
Configure the short key settings.
Page 189
4. CH CONT
Turn channel control on/off
Page 192
5. Independent
load
Turn the load module control to
dependent (via mainframe) or
independent control.
Page 193
6. Delay Time
Configure the load delay time for
each channel. (0-10 seconds).
Page 195
7. Clear All
Protection
Clear all the Protection Alarms.
Page 184
8. Display
Adjust display settings.
Page 211
9. Control type
Configure the Knob control.
Page 215
10. Slave Knob
Setting
Display Measured or Set values
with the selector knob.
Page 219
11. Alarm
Configure alarm settings.
Page 217
12. Step
resolution
Configure the step resolution.
Applicable to CC high and low
range, CR high and low range, CV
high and low range and CP high
and low rang.
Page 197
13. Response
Configure the Response setting.
Page 200