GW Instek PEL-2000A Series - Protection Clear

PEL-2000A Series User Manual
184
9. Change the XXP Setting to Clear
to clear the alarm.
OCP Setting Clear
Note
*REV, OTP and CPP cannot be cleared using this
method, the Protection Clear function must be used
instead, see page 184.
See pages 60 and 289 to output alarms via the
Go/NoGo output terminal.
The configuration settings only apply to the
current channel.
Protection Clear
Background
When any of the protection circuits have been
tripped, the Protection Clear function can be used
to reset the alarms.
Alarm will be shown on the Mainframe Status
Panel and an alarm tone will sound by default
when any of the protection settings are tripped.
Alarm
On the local load module, the protection setting
that has been tripped will be displayed.
Example: Reverse voltage protection
OCP
OVP
REV