PEL-2000A Series User Manual
242
GPIB Function Check
To test the GPIB functionality, National
Instruments Measurement and Automation
Explorer can be used. This program is available
on the NI website, www.ni.com., via a search
for the VISA Run-time Engine page, or
“downloads” at the following URL,
http://www.ni.com/visa/
Operating System: Windows XP, 7, 8, 10
Please use the National Instruments
Measurement & Automation Controller
software to confirm GPIB functionality.
See the National Instrument website,
http://www.ni.com for details.
1. Start the NI Measurement and Automation
Explorer (MAX) program. Using Windows,
press:
Start>All Programs>National
Instruments>Measurement & Automation
2. From the Configuration panel access;
My System>Devices and Interfaces>GPIB0
3. Press the Scan for Instruments button.
4. In the Connected Instruments panel the PEL-
2000A should be detected as Instrument 0 with
the address the same as that configured on the
PEL-2000A.
5. Double click the Instrument 0 icon.
To Next Page
Loading...
