GW Instek PEL-2000A Series - Adjusting the Frame Control

OPERATION
213
3. Use the Selector knob to
highlight Contrast.
4. Press the Selector knob to edit
contrast, then turn to increase or
decrease the value.
Contrast 8
5. Press the Selector knob or Enter
to confirm selection.
OR
ENTER
6. Repeat steps 3-5 for the Brightness.
Adjusting the Frame Control
Background
Frame control is used to control a number of
different frame linked mainframes (slaves) with a
master mainframe. For information on frame
control, frame control interface and connection see
pages 55 & 286.
Note
When using frame control, ensure the same firmware
is installed in both master and slave units.
Parameters
Frame CONT
ON/OFF
Panel operation
1. Connect the mainframes using a
frame link connection.
Page 55.
2. On the master mainframe, press
the Shift Key then the Help key
to access the Utility menu.
UTILITY
HELP
SHIFT
3. Press F5 (Other Menu).
F5